User guide
Table Of Contents
- Title Page
- Table of Contents
- Chapter 1 General Information
- Chapter 2 Functions and Operations
- Chapter 3 Getting Started
- Chapter 4 Cable and Antenna Analyzer Measurements
- Chapter 5 Power Monitor Mode
- Chapter 6 High Accuracy Power Meter
- Chapter 7 Handheld Software Tools
- Chapter 8 Master Software Tools
- Appendix A Windowing
- Index
Interface Cable Installation
Communication between the instrument and the PC is accomplished over a null modem se
-
rial cable provided with the instrument (Anritsu part number 800-441, and optional USB to
serial adapter, part number 551-1691, if required).
Step1. Install the null modem serial interface cable to the RS232 Serial Interface con-
nector on the test connector panel.
Step2. Connect the other end of the serial interface cable to the appropriate COM port
connector on the PC.
Step3. Turn on both the instrument and the PC.
7-4
Chapter 7 Handheld Software Tools
HOLD
RUN
START
CAL
AUTO
SCALE
SAVE
SETUP
RECALL
SETUP
LIMIT
MARKER
SAVE
DISPLAY
RECALL
DISPLAY
PRINT
MODE
FREQ/DIST
AMPLITUDE
MEAS/DISP
SYS
ENTER
CLEAR
ESCAPE
ON
OFF
/
1
2
4
5
6
7
8
9
0
3
+
-
.
S332D
COM PORT
S
ERIAL INTERFA
C
E
Figure 7-2. Serial Cable Connection