User guide

NOTES: The Site Master does not allow overlapping limit segments of the
same type. That is, two upper limit segments cannot overlap and two lower limit
segments cannot overlap.
The Site Master also does not allow vertical limit segments. A limit segment in
which the start and end frequencies are the same, but the limit values are differ-
ent, cannot be specified.
Enabling the Limit Beep
Both limit types can indicate a limit violation by enabling the Limit Beep. An audible
"beep" will sound at each data point that violates the defined limit.
Step 1.
Press the LIMIT key (numeric keypad number 7).
Step 2. Press the
Limit Beep soft key. The status window will indicate that the status of
the limit beep is On, and the soft key will remain in the "down" state. Press the
Limit Beep soft key again to disable the limit beep.
Adjusting the Display Brightness
The brightness of the display can be adjusted to accommodate varying light conditions and
to help discern traces.
Step 1. Press the light bulb key (numeric keypad number 1).
Step 2. Adjust the brightness using the Up/Down arrow key.
Step 3.
Press ENTER to save the new setting.
Chapter 3 Getting Started
3-13