User guide

Symbols
Table 2-1 provides a listing of the symbols used as condition indicators on the LCD status
window.
Chapter 2 Functions and Operations
2-17
Icon Symbol
Site Master is in Hold for power conservation. To resume sweeping, press
the
RUN/HOLD key. When running on battery power, after 10 minutes
without a key press, the Site Master will automatically activate the power
conservation mode.
Integrator Failure. Intermittent integrator failure may be caused by inter-
ference from another antenna. Persistent integrator failure indicates a need
to return the Site Master to the nearest Anritsu service center for repair.
Lock fail indication. Check battery. (If the Site Master fails to lock with a
fully charged battery, call your Anritsu Service Center.)
When calibration is performed, the Site Master stores the temperature.
If the temperature drifts outside the specified range, this icon will appear
at the top of the status window, and the
Cal Off message will be displayed.
A recalibration at the current temperature is recommended.
Indicates the remaining charge on the battery. The inner white rectangle
grows longer as the battery charge depletes.
Indicates internal data processing.
The Site Master has been calibrated with discrete Open, Short and Load
components.
The Site Master has been calibrated with the InstaCal Module.
The Site Master has not been calibrated.
The Site Master has been calibrated with discrete Open, Short and Load
components for the frequency supported by the unit.
The Site Master has been calibrated with the InstaCal Module for the fre-
quency supported by the unit.
Table 2-1. LCD Icon Symbols
HOLD
dx
∫
T
6
Cal On
Cal On!
Cal Off
FlexCal On
FlexCal On!