User guide

Keypad Hard Keys
This section contains an alphabetical listing of the Site Master front panel keypad controls
along with a brief description of each. More detailed descriptions of the major function
keys follow.
The following keypad hard key functions are printed in black on the keypad keys.
0-9 These keys are used to enter numerical data as required to setup or per-
form measurements.
+/–
The plus/minus key is used to enter positive or negative values as required
to setup or perform measurements.
·
The decimal point is used to enter decimal values as required to setup or
perform measurements.
ESCAPE
CLEAR
Exits the present operation or clears the status window. If a parameter is
being edited, pressing this key will clear the value currently being entered
and restore the last valid entry. Pressing this key again will close the pa-
rameter. During normal sweeping, pressing this key will move up one
menu level.
Up/Down
Arrows
Increments or decrements a parameter value. The specific parameter value
affected typically appears in the message area of the LCD.
ENTER Implements the current action or parameter selection.
ON
OFF
Turns the Anritsu Site Master on or off. When turned on, the saved system
state at the last turn-off is restored. If the ESCAPE/CLEAR key is held
down while the ON/OFF key is pressed, the factory preset state will be
restored.
SYS Allows selection of system and application setup parameters and the dis-
play language.
2-6
Chapter 2 Functions and Operations