Data Sheet
7
DUAL DISPLAY
The dual display enables users to view two cable and antenna measurements
on the same display. Because you can control the top and bottom displays
independently, you can set markers and limit lines on each display.
This results in significant time savings as there’s no need to make two
measurements.
QUICK NAME MATRIX
The integrated quick name matrix and keyboard enables you to preset up to
42 commonly used names. The quick name matrix allows you to save long
file names with cell site ID, sector information, color coding, measurement
type, frequency, and termination in less than five seconds. Now you can
label the traces of the entire site in minutes instead of hours.
INSTACAL™ CALIBRATION
Although you need to get the job done as quickly as possible, you still need
to make reliable and accurate measurements. Anritsu’s InstaCal module
enables you to make accurate calibrations at the end of the phase stable
cable without connecting a short/open/load. This calibration method can
cut the calibration time by as much as 50 percent and still deliver accurate
calibrations.
STANDARD OSL CALIBRATION
Open-Short-Load (OSL) calibration comes standard with the
Site Master. All errors from source match, directivity, and frequency
response are mathematically removed, allowing you to make accurate
vector-corrected measurements. Directivity is usually the main contributor
to measurement uncertainty, and corrected directivity of 42 dB or better is
common using Anritsu’s precision components.
FLEXCAL™
The Site Master’s FlexCal
™
broadband calibration feature is an
OSL-based calibration method that allows you to perform a broadband
calibration and change the frequency range after calibration without having
to recalibrate the instrument.
RF IMMUNITY
Site Master’s special dithering RF immunity solution enables you to make
accurate cable and antenna measurements even in the presence of strong
RF activity from co-located cell sites.
Dual Display
Quick Name Matrix
InstaCal
CABLE AND ANTENNA ANALYZER HIGHLIGHTS
Return loss, VSWR, cable loss, DTF -
2-port transmission measurements with 32V bias tee -
1-port phase, Smith chart -
Quick Name Matrix reduces trace labeling time in the field -
Optical DTF measurements -
Dual display mode capabilities -
Built-in, editable signal standard and cable standard lists -
Calibration: OSL Cal, FlexCal, InstaCal -
137, 275, 551, 1102, 2204 data points -
< 1 msec per datapoint sweep speed -
Trace overlay and trace math to monitor changes with -
Reference traces
Marker table with automatic peak/valley markers -
GPS tagging -
Limit lines and alarming for providing reference standards -
GPS tagging of data to verify location of tests -
Master Software Tools for post-analysis and report generation -
Enhance Productivity with Dual Displays and Instant Calibration