User Manual

Wireless NVR Kit Manual
24
2, Set the network parameters. In the network setup of the "network setup" can modify the device's IP address, subnet
mask, gateway and other information. You can check the automatic access to IP. Check the E-see net (P2P) and
displaying the E-see net ID is for remote monitoring.
3, After setup, click the "Apply" button to save the setup, or click the "OK" button to save the setup and exit the
settings interface.
Detailed function list：
Function name
Function description
Remarks
IP address
Used to set the IP address of the device, if
you set the IP address manually, you can
manually enter the IP address.
When you cancel the Automatically
getting IP checking box button, you
can manually set the IP.
E-see net（p2p）
When this function is checked, the ID
number is displayed and which is used for
remote monitoring
Subnet mask
Used to set the subnet mask for this device.
Gateway
Used to set the gateway address of the
device.
Physical address
Used to set the hardware address of the
device.
Need to avoid the same physical
address of the device in Lan.
Web port
In the network, used to send video and other
control signals, the default is 80.
Web pages, PC clients and mobile
phones all use this port.
Automatically
get IP
When this function is checked, the IP
address of the device is set to be acquired
automatically. Otherwise, it will be set
manually.
When using the DHCP function, you
can not manually modify parameters
such as IP.
Network
diagnostic
information
If the turning on function is checked, the
network diagnostics function is enabled
Support for diagnostic types include:
network card exception, network
parameter configuration exception,
IPC connection error diagnosis