User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Accessing to the Network Speed Dome
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- 5.1 Storage Settings
- 5.2 Basic Event Configuration
- 5.3 Smart Event Configuration
- 5.3.1 Configuring Intrusion
- 5.3.2 Configuring Line Crossing Detection
- 5.3.3 Configuring Region Entrance Detection
- 5.3.4 Configuring Region Exiting Detection
- 5.3.5 Configuring Unattended Baggage Detection
- 5.3.6 Configuring Object Removal Detection
- 5.3.7 Configuring Face Detection
- 5.3.8 Configuring Audio Exception Detection
- 5.4 PTZ Configuration
- Chapter 6 Speed Dome Configuration
- Appendix
User Manual of Network Speed Dome
73
Figure 6-19 Integration Protocol Settings
2. Enable CGI function.
Check Enable Hikvision-CGI and then select the authentication from the drop-down list.
Digest is the recommended authentication method.
3. Enable ONVIF function.
1) Check Enable ONVIF.
2) Click Add to add a new ONVIF user. Set the user name and the password, and confirm the
password. You can set the user as media user, operator, and administrator.
3) You can select an added ONVIF user, and click Modify to modify the information.
4) You can select an added ONVIF user, and click Delete to delete it.
4. Click Save to save the settings.
ONVIF user account is different from the camera user account. Set ONVIF user account
independently.
User settings of ONVIF are cleared when you restore the camera.
6.2 Configuring Video and Audio Settings
6.2.1 Configuring Video Settings
Steps:
1. Enter the Video settings interface: