User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Accessing to the Network Speed Dome
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- 5.1 Storage Settings
- 5.2 Basic Event Configuration
- 5.3 Smart Event Configuration
- 5.3.1 Configuring Intrusion
- 5.3.2 Configuring Line Crossing Detection
- 5.3.3 Configuring Region Entrance Detection
- 5.3.4 Configuring Region Exiting Detection
- 5.3.5 Configuring Unattended Baggage Detection
- 5.3.6 Configuring Object Removal Detection
- 5.3.7 Configuring Face Detection
- 5.3.8 Configuring Audio Exception Detection
- 5.4 PTZ Configuration
- Chapter 6 Speed Dome Configuration
- Appendix
User Manual of Network Speed Dome
72
Figure 6-18 802.1X Settings
3. Check Enable IEEE 802.1X to enable it.
4. Configure the 802.1X settings, including user name and password.
The EAP-MD5 version must be identical with that of the router or the switch.
5. Click Save to finish the settings.
The camera reboots when you save the settings.
6. After the configuration, connect the camera to the protected network.
Integration Protocol
Purpose:
If you need to access to the camera through the third party platform, you can enable
Hikvision-CGI function. And if you need to access to the device through ONVIF protocol, you can
configure ONVIF user in this interface. Refer to ONVIF standard for detailed configuration rules.
Steps:
1. Enter the Integration Protocol configuration interface.
Configuration > Network > Advanced Settings > Integration Protocol