User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Accessing to the Network Speed Dome
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- 5.1 Storage Settings
- 5.2 Basic Event Configuration
- 5.3 Smart Event Configuration
- 5.3.1 Configuring Intrusion
- 5.3.2 Configuring Line Crossing Detection
- 5.3.3 Configuring Region Entrance Detection
- 5.3.4 Configuring Region Exiting Detection
- 5.3.5 Configuring Unattended Baggage Detection
- 5.3.6 Configuring Object Removal Detection
- 5.3.7 Configuring Face Detection
- 5.3.8 Configuring Audio Exception Detection
- 5.4 PTZ Configuration
- Chapter 6 Speed Dome Configuration
- Appendix
User Manual of Network Speed Dome
49
The Sensitivity of the detection is supported by certain models. Refer to actual display for
details.
9. Repeat the above steps to configure other regions. Up to 4 regions can be set. You can click
Clear to clear all pre-defined regions.
10. Click Arming Schedule to enter the arming schedule setting interface. The time schedule
configuration is the same as the settings of the arming schedule for motion detection. Refer
to Section 5.2.1 Configuring Motion Detection.
11. Click Linkage Method to select the linkage method taken for object removal detection. Refer
to Section 5.2.1 Configuring Motion Detection.
12. Click Save to save the settings.
5.3.7 Configuring Face Detection
Purpose:
Face detection function detects the face appears in the surveillance scene, and some certain
actions can be taken when the alarm is triggered.
Face function is not supported when third stream is enabled. You need do disable the third
stream in Configuration > System > Maintenance > System Service.
Steps:
1. Enter the Face Detection settings interface:
Configuration > Event > Smart Event > Face Detection
2. Check Enable Face Detection.
3. Check Enable Dynamic Analysis for Face Detection, and then the detected face is marked
with green rectangle on the live video.
To mark the detected face on the live video, you need to enable Rules in Configuration >
Local.
4. Drag the slider to set the detection sensitivity. The Sensitivity ranges from 1 to 5. The higher
the value is, the more easily the face can be detected.
5. Click Arming Schedule to enter the arming schedule setting interface. The time schedule
configuration is the same as the settings of the arming schedule for motion detection. Refer
to Section 5.2.1 Configuring Motion Detection.
6. Click Linkage Method to select the linkage method taken for face detection. Refer to Section
5.2.1 Configuring Motion Detection.
5.3.8 Configuring Audio Exception Detection
Purpose:
When you enable this function and audio exception occurs, the alarm actions will be triggered.
Steps: