User Manual

User Manual of Network Speed Dome
34
5.1.4 Configuring Lite Storage
Before you start:
Make sure you have installed SD card for the camera. The camera will detect the available space
of SD card automatically.
Purpose:
When there is no moving object in the monitoring scenario, the frame rate and bitrate of the
video stream can be reduced to lengthen the storage time of the memory card.
Notes:
 Lite storage function varies according to different camera models.
 The video files recorded in lite storage mode will be played back in full frame rate
(25fps/30fps), and thus the playback process is speeded up to the eye.
 After Lite Storage is enabled, the unformatted SD card will be formatted automatically.
Steps:
1. Enter the Lite Storage interface: Configuration > Storage > Storage Management > Lite
Storage
2. Check the Checkbox of Enable to enable the lite storage function.
3. Select the level of lite storage. Low, Medium, and High levels are available.
Note:
After you set the level of lite storage, the system will recommend storage time accordingly.
You can set the storage time according to the recommended days.
4. Input the storage time in the text field. You can view the available space of the SD card on
the page.
5. Click Save to save the settings.
5.2 Basic Event Configuration
Purpose:
This section explains how to configure the network camera to respond to alarm events, including
motion detection, video tampering, and exception. These events can trigger the alarm actions,
such as Send Email, Notify Surveillance Center, etc.
For example, when motion detection is triggered, the network camera sends a notification to an
e-mail address.
 Click to show the PTZ control panel or click to hide it.
 Click the direction buttons to control the pan/tilt movements.
 Click the zoom/iris/focus buttons to realize lens control.
 The functions vary depending on different speed dome models.