Installation Manual

Note:
The camera reboots when you save the settings.
8. After the configuration, connect the camera to the protected network.
Integration Protocol
Purpose:
If you need to access to the camera through the third party platform, you can enable
Hikvision-CGI function. And if you need to access to the device through ONVIF protocol, you can
configure ONVIF user in this interface. Refer to ONVIF standard for detailed configuration rules.
Steps:
1. Enter the Integration Protocol configuration interface.
Configuration > Network > Advanced Settings > Integration Protocol
Figure 6-22 Integration Protocol Settings
2. Check the Enable Hikvision-CGI checkbox and then select the authentication from the
dropdown list. Then you can access to the camera through the third party platform.
3. Check the Enable ONVIF checkbox to enable the function.
4. Click Add to add a new ONVIF user. Set the user name and password, and confirm the
password. You can set the user as media user, operator, and administrator.
5. Click Modify to modify the information of the added ONVIF user.
6. Click Delete to delete the selected ONVIF user.
7. Click to save the settings.
Network Service
Purpose:
You can control the ON/OFF status of certain protocol that the camera supports.
Notes:
Supported services vary according to camera models.
Keep unused function OFF for security concern.
 SDK Service and Enhanced SDK Service