Installation Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Accessing to the Network Speed Dome
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- 5.1 Storage Settings
- 5.2 Basic Event Configuration
- 5.3 Smart Event Configuration
- 5.4 PTZ Configuration
- 5.4.1 Configuring Basic PTZ Parameters
- 5.4.2 Configuring PTZ Limits
- 5.4.3 Configuring Initial Position
- 5.4.4 Configuring Park Action
- 5.4.5 Configuring Privacy Mask
- 5.4.6 Configuring Scheduled Tasks
- 5.4.7 Clearing PTZ Configurations
- 5.4.8 Configuring Smart Tracking
- 5.4.9 Prioritize PTZ
- 5.4.10 Position Settings
- 5.4.11 Rapid Focus
- Chapter 6 Camera Configuration
- Appendix
HTTPS is enabled by default. The camera creates an unsigned certificate automatically.
When you visit the camera via HTTPS, the web browser will send a notification about the
certificate issue. Install a signed-certificate to the camera to cancel the notification.
Steps:
1. Enter the HTTPS settings interface.
Configuration > Network > Advanced Settings > HTTPS
2. Check Enable HTTPS to enable the HTTPS function.
3. (Optional) Check Enable HTTPS Browsing to access the camera only via HTTPS protocol.
4. Create the self-signed certificate or authorized certificate.
Figure 6-14 Create Certificate
OPTION 1: Create the self-signed certificate
(1) Select Create Self-signed Certificate.
(2) Click Create to create the following dialog box.
Figure 6-15 Create Self-signed Certificate
(3) Enter the country, host name/IP, validity and other information.
(4) Click OK to save the settings.
Note:
If you already had a certificate installed, the Create Self-signed Certificate is grayed out.
OPTION 2: Create the request and import the authorized certificate.
(1) Select Create the certificate request first and continue the installation as the