Installation Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Accessing to the Network Speed Dome
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- 5.1 Storage Settings
- 5.2 Basic Event Configuration
- 5.3 Smart Event Configuration
- 5.4 PTZ Configuration
- 5.4.1 Configuring Basic PTZ Parameters
- 5.4.2 Configuring PTZ Limits
- 5.4.3 Configuring Initial Position
- 5.4.4 Configuring Park Action
- 5.4.5 Configuring Privacy Mask
- 5.4.6 Configuring Scheduled Tasks
- 5.4.7 Clearing PTZ Configurations
- 5.4.8 Configuring Smart Tracking
- 5.4.9 Prioritize PTZ
- 5.4.10 Position Settings
- 5.4.11 Rapid Focus
- Chapter 6 Camera Configuration
- Appendix
Higher value means higher resemblance requirement to continue tracking.
5.4.9 Prioritize PTZ
Steps:
1. Enter the Prioritize PTZ interface:
Configuration > PTZ > Prioritize PTZ.
Figure 5-33 Prioritize PTZ
2. Select Network or RS-485 from the dropdown list
3. Set the delay time.
4. Click to save the settings.
5.4.10 Position Settings
Purpose:
You can configure the position settings in this interface, including the position information of the
device.
Note: Position settings may not be supported by certain camera models.
Steps:
1. Enter the Position Settings interface:
Configuration > PTZ > Position Settings
Figure 5-34 Position Settings
2. Manually find the north position for the speed dome in Live View interface, and click Set at
North to set the north direction.