Installation Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Accessing to the Network Speed Dome
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- 5.1 Storage Settings
- 5.2 Basic Event Configuration
- 5.3 Smart Event Configuration
- 5.4 PTZ Configuration
- 5.4.1 Configuring Basic PTZ Parameters
- 5.4.2 Configuring PTZ Limits
- 5.4.3 Configuring Initial Position
- 5.4.4 Configuring Park Action
- 5.4.5 Configuring Privacy Mask
- 5.4.6 Configuring Scheduled Tasks
- 5.4.7 Clearing PTZ Configurations
- 5.4.8 Configuring Smart Tracking
- 5.4.9 Prioritize PTZ
- 5.4.10 Position Settings
- 5.4.11 Rapid Focus
- Chapter 6 Camera Configuration
- Appendix
Notify Surveillance Center, Send Email, Upload to FTP, Trigger Channel, Smart Tracking,
White Light Flashing, Audible Warning, and Trigger Alarm Output are selectable.
For speed dome, you can also choose to link smart tracking. Smart Tracking should be
configured in advance.
For certain models, White Light Flashing and Audible Warning are supported. Refer to
Section 5.2.1 Configuring Motion Detection for detailed configuration.
10. Click button to save the settings.
5.3.7 Unattended Baggage Detection
Purpose:
Unattended baggage detection function detects baggage which is left in a pre-defined virtual
region, and some certain actions can be taken when the alarm is triggered.
Steps:
1. Enter the Unattended Baggage Detection settings interface:
Configuration> Event > Smart Event> Unattended Baggage Detection
2. Check the checkbox of Enable to enable the Unattended Baggage Detection function.
Figure 5-23 Configuring Region Exiting Detection
3. The event triggered and park action related PTZ movement will be locked for 180 seconds
after you enter the unattended baggage detection interface. Optionally, you can click the
button to manually activate the movement, or lock the movement
when the button turns to by clicking it.
4. Select the region from the dropdown list for detection settings.