Installation Manual

Configuration> Event > Smart Event> Region Entrance Detection
2. Check the checkbox of Enable to enable the Region Entrance Detection function.
Figure 5-21 Configuring Region Entrance Detection
3. The event triggered and park action related PTZ movement will be locked for 180 seconds
after you enter the line crossing detection interface. Optionally, you can click the
button to manually activate the movement, or lock the movement
when the button turns to by clicking it.
4. Select the region from the dropdown list for detection settings.
5. Click the button to start the region drawing.
6. Click on the live video to specify the four vertexes of the detection region, and right click to
complete drawing.
Repeat the step to configure other regions. You can click the button to clear all
pre-defined regions.
7. Configure the parameters for each defense region separately.
 Sensitivity: The value of the sensitivity defines the size of the object which can trigger
the alarm, when the sensitivity is high, a very small object can trigger the alarm.
8. Click tab to enter the arming schedule setting interface. The time schedule
configuration is the same as the settings of the arming schedule for motion detection. Refer
to Section 5.2.1 Configuring Motion Detection for more details.
9. Click tab to select the linkage method taken for the region entrance alarm,
Notify surveillance center, send email, upload to FTP, trigger channel, smart tracking, White
Light Flashing, Audible Warning, and trigger alarm output are selectable.
 For speed dome, you can also choose to link smart tracking. Smart Tracking should be
configured in advance.
 For certain models, White Light Flashing and Audible Warning are supported. Refer to
Section 5.2.1 Configuring Motion Detection for detailed configuration.
10. Click to save the settings.