Installation Manual

Notes:
 Up to 8 NAS disks can be connected to the camera.
 To initialize, refer to the steps of NAS disk initialization
5.1.4 Configuring Lite Storage
Before you start:
Make sure you have installed SD card for the camera. The camera will detect the available space
of SD card automatically.
Purpose:
When there is no moving object in the monitoring scenario, the frame rate and bitrate of the
video stream can be reduced to lengthen the storage time of the memory card.
Notes:
 Lite storage function varies according to different camera models.
 The video files recorded in lite storage mode will be played back in full frame rate
(25fps/30fps), and thus the playback process is speeded up to the eye.
 After Lite Storage is enabled, the unformatted SD card will be formatted automatically.
Steps:
1. Enter the Lite Storage interface: Configuration > Storage > Storage Management > Lite
Storage
Figure 5-9 Lite Storage Settings
2. Check the Checkbox of Enable to enable the lite storage function.
3. Select the level of lite storage. Low, Medium, and High levels are available.
Note:
After you set the level of lite storage, the system will recommend storage time accordingly.
You can set the storage time according to the recommended days.
4. Input the storage time in the text field. You can view the available space of the SD card on
the page.
Click to save the settings.