Installation Sheet

I
NNOVATIVE SITE LIGHTING
© 2016 ANP Lighting. All rights reserved. These specications are intended for general purposes only.
ANP reserves the right to change material or design, without prior notice, in a continuing effort to upgrade its products.
1-800-548-3227
ANPlighting.com
RLM CORD MOUNT INSTALLATION INSTRUCTIONS
03012018
Prior to installation, disconnect power
at main electrical box.
Thread nipple (D)/jam nut (E) into strap
as shown, allowing approximately 3/4”
below strap. Tighten jam nut.
Pull cord (A) through bushing (B), canopy
(C), nipple (D)/jam nut (E)/hanger bracket
(F) as shown.
Pull cord thru hanger bracket to adjust
height, position cord clamp (G) with
ange down, near nipple and use pliers
to tightly crimp the cord clamp.
Hold bracket to canopy to check xture
height.
Cut wires to provide 6” pigtail with junc-
tion box. Jacket can be cut back to 3/4”
from clamp.
Make power and ground wiring connec-
tions.
Slip canopy over nipple and secure with
bushing. Adjust nipple as needed so
canopy is ush to ceiling.
1.
2.
3.
4.
5.
6.
7.
8.
IMPORTANT
Safety, Warning and Suggestions
1. Qualied electrician is required to install this product/s.
2. Please read instructions carefully before installation.
3. All wiring and installations should meet local, state and national electrical codes.
4. Install correct lamp type and wattage.
Prior to installation, disconnect power
at main electrical box.
Attach RTC Box to Ceiling.
Attach Cord Adapter (A) to Flat Ceiling
Canopy using Nipple (C), Washer (D),
and Nut (E).
Feed Cord (F) through Cord Adapter (A)
and Nipple (C). Use Cord Clamp (G) to
crimp around cord jacket.
Make wiring connections according to
national and local codes.
Attach Flat Ceiling Canopy to RTC box
with screws (I) provided.
1.
2.
3.
4.
5.
6.
Cord Mount with RTC
Cord Mount
Nut
Cord Clamp
Nipple
Cord Adapter
Washer
Screws
Cord
Flat Ceiling
Canopy
RTC Box
Standard 4/0 Junction Box
(by others)
Ground Wire
Nipple
Jam Nut
Hanger Bracke
Cord Clamp
Canopy
Bushing
Cord
3/4” Minimum
Approximately 3/4”