Installation Sheet

© 2018 ANP Lighting. All rights reserved. These specications are intended for general purposes only.
ANP reserves the right to change material or design, without prior notice, in a continuing effort to upgrade its products.
1-800-548-3227
ANPlighting.com
M + D CORD MOUNT INSTALLATION INSTRUCTIONS
05172018
Standard 4/0 Junction Box
(by others)
Ground Wire
Nipple (D)
Jam Nut (E)
Cord Clamp (G)
Hanger Bracket (F)
Canopy (C)
Bushing (B)
Cord (A)
3/4” Minimum
Approximately 3/4”
RTC Cover Plate (B)
Arm (A)
Set Screws (C)
Screws (E)
RTC Box (D)
RTC Cover Plate (B)
Arm (A)
Set Screws (C)
Screws (D)
Standard 4/0 Junction Box
(by others)
Prior to installation, disconnect power
at main electrical box.
Thread nipple (D)/jam nut (E) into strap
as shown, allowing approximately 3/4”
below strap. Tighten jam nut.
Pull cord (A) through bushing (B), canopy
(C), nipple (D)/jam nut (E)/hanger bracket
(F) as shown.
Pull cord thru hanger bracket to adjust
height, position cord clamp (G) with
ange down, near nipple and use pliers
to tightly crimp the cord clamp.
Hold bracket to canopy to check xture
height.
Cut wires to provide 6” pigtail with junc-
tion box. Jacket can be cut back to 3/4”
from clamp.
Make power and ground wiring connec-
tions.
Slip canopy over nipple and secure with
bushing. Adjust nipple as needed so
canopy is ush to ceiling.
1.
2.
3.
4.
5.
6.
7.
8.
Cord Mount
IMPORTANT
Safety, Warning and Suggestions
1. Qualied electrician is required to install this product/s.
2. Please read instructions carefully before installation.
3. All wiring and installations should meet local, state and national electrical codes.
4. Install correct lamp type and wattage.