User's Guide

7
STOP! READ BEFORE PROCEEDING
HEATING ELEMENT PREPARATION
1. Make sure the Oven is situated in a
well-ventilated area and plugged in.
2. Remove all original packaging, as well as
accessories, from the appliance.
3. Set the oven to 350°F (176°C) using the
   for 15 minutes
and press .
4. Allow the oven to cool. Open the door to
allow air to ventilate out.
Set the oven at 350°F (176°C) using the
     for
15 minutes and press .
5. Clean the appliance and the accessories
before fi rst use. Refer to “Care and
Cleaning” section for details.
NOTE: The heating elements may create some
vapors and odors as their coatings burn o .
ATTACH PARTS
Install the Water Tank by sliding it from front
to back along the right side of the Oven. Fill
with distilled water. Do not overfi ll past the
 water line.
Attach the included Drip Tray by sliding it
under the Oven door with the open
reservoir side facing up.
NOTE: Distilled water is recommended to minimize
scale buildup and maintain correct operating function.
Prepare the Oven before use. Refer to diagrams and information
on pages 4–10 of this guide for operation details.
Anova_Oven_Guide_FINAL.indd 7Anova_Oven_Guide_FINAL.indd 7 6/9/20 5:41 PM6/9/20 5:41 PM