Specifications

14
15
*Both Fade time and Standing time use the same conversion table in order to convert DMX value to the time value:
DMX Time
[sec.]
DMX Time
[min.]
DMX Time
[min.]
DMX Time
[min.]
DMX Time
[min.]
1 0.1 50 4.2 105 18.4 160 42.7 215 77
2 0.4 55 5 110 20.2 165 45.4 220 80.7
5 2.5 60 6 115 22 170 48.2 225 84.4
10 10 65 7 120 24 175 51 230 88.2
15 22.5 70 8.2 125 26 180 54 235 92
20 40 75 9.4 130 28.2 185 57 240 96
25 62.5 80 10.7 135 30.4 190 60.2 245 100
30 90 85 12 140 32.7 195 63.4 250 104
35 122.5 90 13.5 145 35 200 66.7 255 108
40 160 95 15 150 37.5 205 70
45 202.5 100 16.7 155 40 210 73.5
Exact expression of the time value follows the formula: time[sec.]=(DMX value)
2
/10.
MASt. --- Master.Enter this menu if you want to set the the xture as a master.Use [UP] and [DOWN] buttons to select
desired program and press [ENTER] to conrm selection.
SLA. --- Slave.Select this menu if you want to set the the xture as a slave.
7.6 Reset function
This option enables the ArcWash Recessed 136 RGB to index all effects and return them to their standard positions.
7.7 Special functions
Use this menu for special services like software update.
uPd.M. ---Updating mode.Using this function you can update software in the xture via PC and serial link.
The following are required in order to update software:
- PC running Windows 95/98/2000/XP or Linux
- DMX Software Uploader
- Flash cable RS232/DMX (No.13050624)
Note1:Software update should execute a qualied person.If you lack qualication, do not attempt the update
yourself and ask for help your ROBE distributor.
Note 2:DMX address, IP address ,programs 1-3 and all functions in menu "PErS" will be set to their default values.
To update software in the xture:
1.Installation of DMX Software Uploader.
1.DMX Software Uploader program is available from the ROBE web site at WWW.robe.cz.
2.Make a new directory ( e.g. Robe_Uploader) on your hard disk and download the software to it.
3.Unpack the program from the archive. If the Robe xture is produced in magnetic and electronic
ballast version, name of DMX Software Uploader is the same for both versions.
2.Fixture software updating.
1.Determine which of your COM port is available on your PC and connect it with to the DMX input
of the fixture using the uploading cable. Do not extend this cable! Disconnect the fixture from the
other xtures in DMX chain! Turn on the computer and the xture. Make sure the lamp is
switched off.
2.Switch the xture to the update mode by selecting the option Updating mode in menu Special
Functions on the xture control panel:SPEC-->UPd-->yES.(From this option you cannot return back
to the main menu. If you do not want to continue in software update, you have to switch off and on the xture
to leave this option!)