Specifications
12
13
7. Functions of the control panel
The control panel situated on the front panel of the base offers several features. You can simply set the DMX address,
run programs, make a reset and also use many functions for setting the xture behaviour.
Control elements on the control board:
[MODE] button-leaves menu without saving changes.
[ENTER] button- enters menu,conrms adjusted values and leaves menu.
[UP] button and[DOWN] button- moves between menu items on the the same level, sets values.
After switching the xture on,the display shows the initial screen:
Use [UP],[DOWN] to browse through the menu. To select a function or submenu,press [ENTER].
7.1 Fixture Address
Use this menu to set the DMX start address of the xture, which is dened as the rst channel from which the ArcWash
Recessed 136 RGB will respond to the controller.
If you set, for example, the address 15, the
ArcWash Recessed 136 RGB
will use the channel 15 to 28 for control (if Mode
1 is selected).
Please, be sure that you don’t have any overlapping channels in order to control each ArcWash Recessed 136 RGB
correctly and independently from any other xture on the DMX data link.
If two, three or more ArcWash Recessed 136 RGB are addressed similarly, they will work similarly.
After having addressed all ArcWash Recessed 136 RGB, you may now start operating these via your lighting control-
ler.
Note: After switching on, the ArcWash Recessed 136 RGB will automatically detect whether DMX 512 data is received
or not.
If there is no data received at the DMX-input, the display will start to ash „A001” with actually set address.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the ArcWash Recessed
136 RGB.
-
the controller is switched off or defective, the cable or connector is defective or the signal wires are swaped in the input connec-
tor.
7.2 Fixture informations
Use this menu to read an useful information about the xture.
tEMP ---Fixture temperature.The function shows the temperature in the xture head (°C).Please note that the outside
temperature should not exceed 40° C.
VErS. --- Software version.Select this function to read the software version of processors:
IC1.b.--- Main processor on the main board in the xture base
IC2.b.--- Pan/tilt processor on the main board in the xture base
7.3 Personality
Use this menu to to modify the ArcWash Recessed 136 RGB operating behavior.
r.PAn --- Pan reverse.Select this function to invert the pan movement.
r.tilt --- Tilt reverse.Select this function to invert the tilt movement.