User Manual

Page 9 of 20
• Grasp the handle in the lower front of the water tank and pull out.
Note: The water tank cannot be pulled out fully. This is to prevent
accidental water spillage.
• The Rubber Drain Plug is located as shown below.
• Ensure this rubber plug is pushed all the way down into the drain hole
before adding water.
• Ensure the cooler is standing on a flat and level
surface and in the position the cooler will be
operated from, then water can be added.
CAUTION: Moving the cooler when the water has
been added, especially to the Maximum level
mark, may cause water to spill over and onto your
floor.
Water Pump and
Water Level Sensor
Rubber Plug