User Manual

Page 18 of 20
7.2 Water Pump
The water pump is attached to the bottom of the water tank and the water
intake grille may become blocked over time, especially if the water is not
very clean.
• To clean the grille of the pump, first turn off and unplug the cooler from
the power point.
• Using a very soft brush or cloth, gently wipe the front of the grille to
remove any debris.
• Rinse out the water tank and refill with fresh clean water.
8 Storage
• Switch off and unplug the unit from mains power.
• Ensure all water is removed from the water tank.
• Without the “Cool” function switched on, allow the unit to run for 1 – 2
hours without water so as to dry it quicker.
More time may be required depending on how humid the ambient air
is.
• Coil the power cord loosely and place next to the unit.
• Remove the Batteries from the Remote Control.
• When the appliance is totally dry, refit the water drain plug (if removed)
and store the cooler in a dry well-ventilated area.
Read and Save These Instructions
Water Intake Grille
this side