User Manual

Page 13 of 20
6 Operation
Important: Refer to the Section “Preparation” prior to Operation.
Note: This cooler has a “Memory”.
The Memory function will remember the settings last used when the
evaporative cooler is turned Off with the On/Off button and will re-use the
same settings (excluding the Cool function) when it is switched on again
providing the cooler is not unplugged in-between uses.
NOTE: Memory function is not available for Sleep mode and Timer Function.
6.1 ON/OFF
• Insert the power plug into a power point and switch on. A short “Beep”
will be heard.
• Press the “ON/OFF” button on the control panel (or remote
control). The unit will start in the default “Low” Speed as
indicated by the indicator light and Normal Mode.
Note: If the “Cool” function was used prior to turning off after the last
use, the Cool function will not turn back on with memory. This is to
prevent damage to the water pump should there be no water in the
water tank.
6.2 Wind Modes
Press the “Mode” button to select between, “Normal”, “Natural”
and “Sleep” fan wind patterns.
a. NOR: The Normal Default Mode is set by default when the unit
is first turned on. The wind remains a constant flow.
Note: There is no indicator light for Normal default mode.
b. SLP: The “Sleep” mode (No Mode Light) creates wind patterns that are the
same as the Natural Mode wind patterns, however, when the fan is set to
either Medium or High Speed, the pattern will drop a speed level after
approximately 30 minutes.
For Example: If High Speed Fan and the Sleep Mode are selected, this will
be the same wind pattern as the High-Speed setting in Natural Mode.
However, after approximately 30 minutes, the wind pattern will automatically
drop down to the same wind pattern as if Natural Mode was selected at
Medium fan speed.
After approximately a further 30 minutes, the wind pattern will automatically
drop down to the same wind pattern as if Natural Mode was selected at low
fan speed.