User Manual

Page 10 of 20
If you need to move the cooler, switch off and unplug the cooler, and
ensure that the water level is at least only ¾ full or less to reduce the
chance of spilling water.
• Fill the water tank with fresh clean cold water until the level has reached
the Maximum mark on the rear of the Water Tank. DO NOT OVERFILL.
• Ice blocks can also be added which will help cool the water / air. Add Ice
first and then fill with water.
• Do Not Fill with any liquid other than clean cold water. Do Not add any
additives to the water.
• Gently push the water tank back in to avoid
spilling and rotate the Water Tank Lock to secure
the Water Tank.
• When the water tank has been pushed in and
secured, the water level can now be monitored
from the front of the cooler by means of the water
indication window.
Note: The front window is just an indication of water being in the tank
and is not a true level indicator. Refer to the markings on the Water Tank
for actual levels.
• When the water has been used up, the water pump will turn off and the
Indicator light above the “Cool” button with blink with three beeps.
• Refill the water tank when the water level reaches the “Min” level mark,
or when the indicator light blinks, or turn off the “Cool” function.
Refer to instruction under the heading “Cool” for the operation of this
function.