Instruction Manual

1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Remove the drawer.
Carefully lay the cot down on the back panel.
Remove the bottom shelf set completely.
Remove the 4 x Filler bolts and nuts from the lower base position on the
end panels.
Remove 4 x 30mm Mattress base bolts then loosen the bolts of one end
panel.
Carefully slide the Mattress Base to the lower position. Ensure the
pre-assembled dowel in the mattress base correctly inserts into the
pre-drilled dowel hole in the end panel.
Secure the Mattress Base using 4 x 30mm Mattress base bolts. Tighten
until firm.
Re-fit 4 x Filler bolts and nuts to the upper Mattress Base mounting holes
to prevent possible finger entrapment.
Re-attach the bottom shelf set.
Carefully stand the cot upright. Check all bolts are tightened until firm.
Re-assemble the drawer.