8 kg MAXIMUM WEIGHT OF CHILD WOODEN COT WITH DRAWER INSTRUCTION MANUAL 5 kg DRAWER MAXIMUM LOADING Drawings/images in the manual are for visual purposes only. Actual product may vary slightly. or feature without prior notice.
the gaps between the mattress and the sides and ends of the cot will not exceed 40mm when the mattress is pushed to one side or end, and 20mm when the mattress is centred in the cot. This is to minimise the danger of a child’s limb becoming caught in the gap. the depth of the cot is greater than 500mm with the mattress base in the lower position and is greater than 300mm with the mattress base in the upper position to minimise the risk of a child climbing or falling out of the cot.
WARNING: ADULT ASSEMBLY REQUIRED: DUE TO THE PRESENCE OF SMALL PARTS DURING ASSEMBLY, KEEP OUT OF REACH OF CHILDREN UNTIL ASSEMBLY IS COMPLETE. TO PREVENT FALLS, THE MATTRESS BASE OF THIS COT SHOULD BE ADJUSTED TO THE LOWEST POSITION BEFORE THE CHILD CAN SIT UP UNAIDED. FOLLOW THE MANUFACTURER’S ASSEMBLY INSTRUCTIONS TO ENSURE THE SAFETY FEATURES OF THE COT ARE NOT COMPROMISED. This cot has been manufactured for one child only, with a maximum weight of 18kgs.
Mattress Base in Low Position This base height is set for an active baby who can sit up unaided.
1. Remove the drawer. 2. Carefully lay the cot down on the back panel. 3. Remove the bottom shelf set completely. 4. Remove the 4 x Filler bolts and nuts from the lower base position on the end panels. 5. Remove 4 x 30mm Mattress base bolts then loosen the bolts of one end panel. 6. Carefully slide the Mattress Base to the lower position. Ensure the pre-assembled dowel in the mattress base correctly inserts into the pre-drilled dowel hole in the end panel. 7.
CRUSH HAZARD CLOSING DRAWERS MAY CAUSE INJURY TO YOUR HANDS OR FINGERS. ALWAYS CLOSE OR OPEN DRAWERS USING HANDLES. KEEP HANDS AWAY FROM DRAWER EDGES WHEN OPENING OR CLOSING DRAWERS. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY OR CUTS.
