User Manual

Page 9 of 12
• Heat Button: With the Controller switched on (out of standby), press this
button and the Massager heater will start to heat on Maximum power.
The Indicator light will illuminate
bright indicating it is on Maximum power.
Press this button again, and the Heater will reduce to Low power
indicated by the indicator light dimming.
Press this button again, the Heater will turn Off.
Note: You may use this heat function whilst using the massager in any
mode.
Press the On / Off button to turn the massager off.
Note: The massager / Heat will automatically turn off after approximately 30
minutes, or alternatively, you can manually turn off before the 30 minutes has
passed.
5.3 Massage Belt
To fit the massager belt, place the belt around your lower back, with the controller
and power cables at the bottom, and the Quilted side of the fabric facing outward.
Bring the side tabs around to your front and secure with the hook and loop
fastener.
Should you require the belt to be longer, there is an extension piece supplied.
Secure the extension piece to one of the belt tabs and then bring the side tabs
around to your front and secure with the hook and loop fastener.
You are now ready to use your Massager Belt with Heat.