User Manual

IMPORTANT! After setting, the shown temperature on the display screen is the ambient
temperature. The heater will start to function only when the set temperature is higher
than the ambient temperature.
4. Timer setting:
Timer can be set from 1h - 24h.
Press the Timer button "
", the icon will flash, press buttons " " " " to select the
desired range between 1 to 24 hours. The timer will increase or decrease by 1 hour after
each press. In the timer setting, the timer symbol
will light on and be shown on the
display. The setting will be memorized and confirmed after 3 seconds.
For example, if you set the timer to 1 hour, the heater will switch OFF automatically after 1
hour.
5. Child Lock
Press the “+” and “-“ button simultaneously for 5 seconds to activate the child lock function
for ON or OFF. The symbol "
" will light up or go out on the LED display.
Settings can be adjusted again after turning off the child lock function.
Note: This function can only be set from the heater, and not by remote control.
OPERATING SOUND
The appliance emits a beep upon each operation setting.
NOTE: There is a tip-over switch inside the heater. If the heater is knocked over, the power
to the heater will shut off automatically.
WARNING! FOR ELECTRICAL SAFETY THIS APPLIANCE MUST BE PLUGGED INTO
AN EARTHED ELECTRICAL POWER SOCKET OUTLET! – If you are uncertain,
please consult an electrician.
CLEANING AND MAINTENANCE
Before cleaning
- When not in use or before cleaning, always disconnect the
appliance from mains power supply.
Cleaning
- Cleaning must be done only when the heater has cooled down
completely.
- Do not immerse the whole unit in water or other liquid.
- Do not use harsh solvents on the unit.
- Wipe the exterior of the appliance with a soft damp cloth.
- Dry the unit completely with a dry cloth.