User Manual

WARNING: Do not ingest battery, Chemical Burn Hazard.
This product contains a coin/button cell battery. If the coin/button cell battery is
swallowed, it can cause severe internal burn in just 2 hours and can lead to death.
Keep new and used batteries away from children. If the battery compartment does not
close securely, stop using the product and keep it away from children. If you think
batteries might have been swallowed or placed inside any part of the body, seek
immediate medical attention.
REMOTE CONTROL OPERATING RANGE
• When there is an obstacle between the heater and the transmitter, the heater may
not operate.
• When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong
light shines on the REMOTE SENSOR of the unit, the operation of remote control may
be unstable.
FOOT ASSEMBLY
The device must be installed so that airflow is not obstructed.
• Carefully turn the unit upside down. Use the Screws to fix the Feet onto the Heater.
Take care to ensure that they are located correctly at the bottom ends of the heater
side molding.
• Be sure to place the convection heater on a flat surface.
DIGITAL SCREEN AND REMOTE CONTROL OPERATION
THIS APPLIANCE MUST BE EARTHED.
• Ensure the ON/OFF control switch is in the OFF (position ‘0”) position before
connecting to mains power.
• Make sure the appliance, including the plug and cord, is not damaged.
• Insert power plug into a wall socket with correct power output, 220-240V 50Hz.
The buttons of touchscreen located on the product correspond to the remote control
functions.