Tus neeg siv phau ntawv
Table Of Contents
- KNOW YOUR ESPRESSO COFFEE MAKER
- FROTHING MILK
- 1. Turn the Steam Controller all the way to “OFF” position to close the steam nozzle.
- 2. Use the handle to turn the milk frother out to the side of the machine.
- 3. Press the Steam button “”, and the Steam indicator light will start flashing.
- 4. Wait until the Steam indicator light stop flashing.
- 5. Fill approx. 100ml of cold milk in milk jug. Ideally, a milk jug is made of stainless steel.
- 6. Pick up the milk jug and guide the nozzle of milk frother and immerse it lightly into the milk.
- 7. Hold the milk jug at a slight angle and turn the Steam controller to the “/” position.
- 8. Move the milk jug up and down slightly, but ensure the nozzle is always immersed in the milk.
- 9. Once you have created sufficient milk froth, close the Steam controller and place the milk jug aside. Wipe the nozzle with a clean damp cloth.
- 10. Press the Power button to turn OFF the machine.
- After milk frothing, the steam nozzle must be cleaned. Not doing so may result in steam blockage.
- Press the power button “” to turn off the machine.
- Pull the power plug off from the mains power outlet socket.
- Allow the machine cool down for a few minutes.
- Quick clean
- Wipe all parts with a damp soft cloth, such that coffee grounds and milk residues do not dry on the machine.
- Empty the drip tray
- The drip tray needs emptying as soon as the red overfill indicator pops up.
- Carefully lift the drip tray off the espresso machine, remove the draining rack and pour the water into the sink.
- Dispensing amount for a single-cup
- Dispensing amount of double-cup
- Restore factory setting
- After pressing the power ON button, if there is no function selected within 29 minutes, the unit will power off automatically.
- After pressing the power button, if there is no function selected after the water pump has operated for more than 180 seconds during frothing, the pump will stop automatically.
IMPORTANT! you may need to turn the
handle a little harder to make the holder stop
at the right locking position. This is
important to prevent the holder from
ejecting during use due to steam pressure.
Fig. 2
Insert
drip tray.
Put a coffee cup underneath
the coffee spout of the filter holder.
Note:
The appliance is not equipped with a
cup. Please use your own coffee cup
Turn the
steam controller
to “
OFF
” position
to close the steam nozzle.
Insert the plug into a mains power outlet
socket. Press the power button “ ” to
power on the unit.
The
Power indicator
will be illuminated and
the single-cup / double-cup / steam indicator
lights will begin to flash.
Wait until the single-cup / double-cup / steam
indicator lights stop flashing.
Press the
Single-cup
“ ” or
double-cup
button
“ ” , and hot espresso will flow
into the cup(s).
The appliance will stop working when the
coffee-brewing is finished, then your coffee
is ready.
Risk of burning!
Parts of the espresso machine become very hot during and
immediately after operation. Do not touch hot surfaces, especially the metal parts.
Always touch handles or wait until parts have cooled down.
Risk of scalding
! Rising steam can cause burns. Be aware hot water/hot steam that
may escape from the espresso machine during use.