Tus neeg siv phau ntawv
Table Of Contents
- KNOW YOUR ESPRESSO COFFEE MAKER
- FROTHING MILK
- 1. Turn the Steam Controller all the way to “OFF” position to close the steam nozzle.
- 2. Use the handle to turn the milk frother out to the side of the machine.
- 3. Press the Steam button “”, and the Steam indicator light will start flashing.
- 4. Wait until the Steam indicator light stop flashing.
- 5. Fill approx. 100ml of cold milk in milk jug. Ideally, a milk jug is made of stainless steel.
- 6. Pick up the milk jug and guide the nozzle of milk frother and immerse it lightly into the milk.
- 7. Hold the milk jug at a slight angle and turn the Steam controller to the “/” position.
- 8. Move the milk jug up and down slightly, but ensure the nozzle is always immersed in the milk.
- 9. Once you have created sufficient milk froth, close the Steam controller and place the milk jug aside. Wipe the nozzle with a clean damp cloth.
- 10. Press the Power button to turn OFF the machine.
- After milk frothing, the steam nozzle must be cleaned. Not doing so may result in steam blockage.
- Press the power button “” to turn off the machine.
- Pull the power plug off from the mains power outlet socket.
- Allow the machine cool down for a few minutes.
- Quick clean
- Wipe all parts with a damp soft cloth, such that coffee grounds and milk residues do not dry on the machine.
- Empty the drip tray
- The drip tray needs emptying as soon as the red overfill indicator pops up.
- Carefully lift the drip tray off the espresso machine, remove the draining rack and pour the water into the sink.
- Dispensing amount for a single-cup
- Dispensing amount of double-cup
- Restore factory setting
- After pressing the power ON button, if there is no function selected within 29 minutes, the unit will power off automatically.
- After pressing the power button, if there is no function selected after the water pump has operated for more than 180 seconds during frothing, the pump will stop automatically.
IMPORTANT SAFEGUARDS
Please read the instruction manual before using this appliance and follow all the safety instructions
to avoid damage and/or injury due to improper use.
1. Read all instructions.
2. Before using check that the voltage of wall outlet corresponds to rated voltage marked on the
rating plate.
3. This appliance has been incorporated with a grounded plug. Please ensure the wall outlet in
your house is well earthed.
4. To protect against fire, electric shock and injury to persons do not immerse cord, plug, in water
or other liquid.
5. The appliance must not be immersed in water or other liquid.
6. Remove plug from mains power socket outlet before cleaning and when not in use. Allow
appliance cool down completely before taking off, attaching components or before cleaning.
7. Do not operate the appliance with a damaged cord or plug or after the appliance malfunctions
or is dropped or damaged in any manner. For electrical safety, any repairs on the appliance
must be carried out by a qualified electrical person only.
8. The use of accessory attachments not recommended by the appliance manufacturer may result
in fire, electric shock or injury to persons.
9. Place appliance on flat surface or table, do not hang power cord over the edge of table or counter.
10. Ensure the power cord is placed away from external heat source.
11. Do not place the espresso machine on hot surface or near any heat source, i.e. stove.
12. To disconnect, turn “off” the function switch in use then remove the cord plug from mains
power outlet. Always hold by the plug, never pull on the cord when removing from the mains
power outlet socket.
13. Do not use appliance for other than intended use and place it in a dry environment.
14. Close supervision is necessary when your appliance is being used by or near children.
15. Be careful hot steam can cause burns.
16. Do not touch the hot surfaces on the appliance (such as milk frother, brewing filter and filter
holder when boiling). Use handle or knobs.
17. Do not let the espresso machine operate without water.
18. Scalding may occur if the water tank is removed during the brewing cycles.
19. DO NOT remove the filter holder while brewing coffee. Remove the filter holder 10 seconds
after the brewing cycle to make additional coffee.
20. Caution should also be taken when removing the filter holder since the metal parts will be hot.
Please make sure to hold by the handle and to use the filter holder clip to dispose coffee
grounds.
21. Always allow steam and hot water to escape from the milk frother after brewing. This will
ensure there is no pressure in the boiler when removing the filter holder.
22. Release pressure through milk frother before removing water tank or filter holder.
23. This appliance is not intended for used by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instructions concerning use of the appliances by a person responsible for
their safety.
24. ELECTRIC SHOCK HAZARD! Children should be supervised to ensure that they do not
play with the appliance.