Tus neeg siv phau ntawv
Table Of Contents
- KNOW YOUR ESPRESSO COFFEE MAKER
- FROTHING MILK
- 1. Turn the Steam Controller all the way to “OFF” position to close the steam nozzle.
- 2. Use the handle to turn the milk frother out to the side of the machine.
- 3. Press the Steam button “”, and the Steam indicator light will start flashing.
- 4. Wait until the Steam indicator light stop flashing.
- 5. Fill approx. 100ml of cold milk in milk jug. Ideally, a milk jug is made of stainless steel.
- 6. Pick up the milk jug and guide the nozzle of milk frother and immerse it lightly into the milk.
- 7. Hold the milk jug at a slight angle and turn the Steam controller to the “/” position.
- 8. Move the milk jug up and down slightly, but ensure the nozzle is always immersed in the milk.
- 9. Once you have created sufficient milk froth, close the Steam controller and place the milk jug aside. Wipe the nozzle with a clean damp cloth.
- 10. Press the Power button to turn OFF the machine.
- After milk frothing, the steam nozzle must be cleaned. Not doing so may result in steam blockage.
- Press the power button “” to turn off the machine.
- Pull the power plug off from the mains power outlet socket.
- Allow the machine cool down for a few minutes.
- Quick clean
- Wipe all parts with a damp soft cloth, such that coffee grounds and milk residues do not dry on the machine.
- Empty the drip tray
- The drip tray needs emptying as soon as the red overfill indicator pops up.
- Carefully lift the drip tray off the espresso machine, remove the draining rack and pour the water into the sink.
- Dispensing amount for a single-cup
- Dispensing amount of double-cup
- Restore factory setting
- After pressing the power ON button, if there is no function selected within 29 minutes, the unit will power off automatically.
- After pressing the power button, if there is no function selected after the water pump has operated for more than 180 seconds during frothing, the pump will stop automatically.
Single-cup indicator and
double-cup indicator
flashing quickly.
Machine has not been used for
180s after pressing the power
ON button.
Rotate the knob to off position
to reset.
Steam indicator blinking
quickly.
Boiler temp. is too high
Turn knob to “ ”position,
perform cooling operation
Single-cup indicator or
double-cup indicator lights
blinking quickly.
The knob is not reset to off
position, but the machine is
turned ON.
Reset the knob to “OFF”
position
Single-cup indicator 、
double-cup indicator and
steam indicator blinking
quickly
Coffee maker needs descaling.
Require Decalcifying, Refer to the
heading ‘Descaling’ in this
manual.
TECHNICAL SPECIFICATION
Voltage: 220-240Va.c. 50-60Hz
Wattage: 1250-1450W