ESPRESSO COFFEE MAKER QUICK INSTALLATION GUIDE 1. Align the handle (lever) on the filter holder to the left of Lock symbol. 2. Insert the filter holder slightly into the Expresso Coffee Maker. 3. Turn handle towards the Close symbol until it is tight and secured. 4. To remove filter - take out the filter using the edge of the other filter as follows.
Espresso Coffee Maker CM5418CB-SA User Manual PLEASE READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
IMPORTANT SAFEGUARDS Please read the instruction manual before using this appliance and follow all the safety instructions to avoid damage and/or injury due to improper use. 1. Read all instructions. 2. Before using check that the voltage of wall outlet corresponds to rated voltage marked on the rating plate. 3. This appliance has been incorporated with a grounded plug. Please ensure the wall outlet in your house is well earthed. 4.
25. This appliance is intended to be used in household and similar applications such as: – staff kitchen areas in shops, offices and other working environments, – farmhouses, 26. 27. 28. 29. 30. 31. 32. 33. 34. – by clients in hotels, motels and other residential type environments, – bed and breakfast type environments.
KNOW YOUR ESPRESSO COFFEE MAKER BEFORE THE FIRST USE Remove all the plastic bags, packaging material on the Espresso Machine. Remove the stopper at bottom of water tank.
Prior to initial use and after a longer period of disuse of the Espresso Machine, allow the contents of approx. 2-3 cups of water to run through the machine without adding any coffee powder in the filter. This will clean the water circuit and all parts will be heated up for proper operation. DANGER OF INJURY, BURNING AND SCALDING! PLEASE READ ALL SAFETY INSTRUCITONS AND FAMILIARISE YOURSELF WITH PARTS BEFORE USING THE MACHINE! SETTING UP THE MACHINE Filling the Water tank 1.
Tips Clean excess ground coffee from the rim to ensure proper fit under the brew head and avoid any leaks. The compressing of the espresso powder is an important process for preparation. If the powder is compressed tightly, the espresso will run through slowly and there will be more crema. Pre-heat the machine and cup To prepare a good hot espresso, it is recommended that you heat up the espresso machine prior to each use. 1.
IMPORTANT! you may need to turn the handle a little harder to make the holder stop at the right locking position. This is important to prevent the holder from ejecting during use due to steam pressure. Fig. 2 Insert drip tray. Put a coffee cup underneath the coffee spout of the filter holder. Note: The appliance is not equipped with a cup. Please use your own coffee cup Turn the steam controller to “OFF” position to close the steam nozzle. Insert the plug into a mains power outlet socket.
Emptying the brewing filter 1. Remove the filter holder from the machine. 2. Turn the filter holder to “Lock” mark position, then pull it down gently. 3. Fold the filter blocker up and over the edge to hold the brewing filter. Refer to figure shown. 4. Hold the handle placing your thumb/finger on the filter blocker, this will prevent the filter from falling out, turn it upside down and knock out remove the espresso powder. FROTHING MILK 1.
Cleaning milk frother After milk frothing, the steam nozzle must be cleaned. Not doing so may result in steam blockage. 1. Place an empty large cup underneath the milk frother nozzle. 2. Turn on the steam controller and wait for approx. 15 seconds, then close the steam controller. 3. Wipe the nozzle with a clean damp cloth. 4. Detach the nozzle and wipe the milk frother with a clean damp cloth. IMPORTANT! Ensure the detachable nozzle is fitted firmly back in place after cleaning.
the “Single-cup indicator” flashes at the same time, when the desired amount is dispensed, press the “Single-cup” button again, the coffee will stop dispensing. At that time, the setting for the dispensing amount of single cup is finished and it will be saved for next operation. The adjustable dispensing amount of single cup ranges between 15 seconds and 25 seconds.
Descaling Descale the coffee maker regularly. To do this, use a commercially available descaling product (kettle descaling solution) and follow instructions provided with product. Storage 1. Prior to longer storage, clean the espresso machine thoroughly. 2. Empty the water tank and the drip tray. 3. Allow all parts to dry completely. 4. Store the espresso machine in a dry, frost and dust free location.
Single-cup indicator and double-cup indicator Machine has not been used for 180s after pressing the power ON button. Rotate the knob to off position to reset. Boiler temp. is too high Turn knob to “ ”position, perform cooling operation The knob is not reset to off position, but the machine is turned ON. Reset the knob to “OFF” position Coffee maker needs descaling. Require Decalcifying, Refer to the heading ‘Descaling’ in this manual. flashing quickly. Steam indicator blinking quickly.
12 Month Warranty Thank you for your purchase from Kmart. Kmart Australia Ltd warrants your new product to be free from defects in materials and workmanship for the period stated above, from the date of purchase, provided that the product is used in accordance with accompanying recommendations or instructions where provided. This warranty is in addition to your rights under the Australian Consumer Law.
