Instruction Manual
43024094 AUTOMATIC SOAP DISPENSER
43024094 AUTOMATIC SOAP DISPENSER
OperationInstructions
1. Open battery compartment and insert 4 AAA batteries, ensure that the polarity is correct.
Replace battery cover and screw to close.
2. Press the “on” switch, a blue light will flash to show that it is on.
3. To fill the dispenser, stand the dispenser upright, slide off cover and pull off lid. Pour in
liquid to fill.
4. The dispenser will need to be primed on first use, place your hand 5cm from dispensing
nozzle a few times to draw the liquid up.
5. If the nozzle clogs, gently clean the nozzle to clear any dried debris.
6. Refill when liquid level is low.
7. Do no place in water or allow battery compartment to become wet, the dispenser is not
water proof.
8. Do not place in direct sunlight
9. Remove batteries from the dispenser when not used for extended periods of time or when
batteries are exhausted.
10cm
15cm
5cm is the
best distance
When dispensing,
blue light will flash.
Place open hand 5cm under
dispensing nozzle.
200ML
200MLTOUCH-
FREE
Switch
4AAA batteries
C
L
O
S
E
O
P
E
N
C
L
O
S
E
O
P
E
N
Front Back