Phau Ntawv Qhia

ASSEMBLY
1. Remove the dome nut from the castors, fit castor thread through the castor
mounting plate. Replace dome nut and tighten.
2. Place the heater body upside-down on a scratch-free location, make sure it is
stable and will not fall. Be careful to prevent damage to the cosmetic finish or
your floor surfacing.
3. Unscrew the wing nuts from the U-shaped bolt provided (image 1), fit the U-
shaped bolt over the connector between control panel and second fin (image 2).
4. Insert the threaded ends of the U bolt in the holes on the C shaped castor plate
(image 3) Note the C shaped castor plate should be placed with the castors
pointed towards the control panel.
5. Screw the wing nuts back to the U bolt and tighten the wing nut securely (image
4).
Note: do not over-tighten, which may cause damage to the heater.
6. Repeat steps 3, 4 and 5 on the rear of the heater for mounting of the rear castors.
Note the C shaped castor plate should be placed with the castors pointed out the
back of the heater.
Note: the rear castors must be mounted between the end two fins.
IMPORTANT: Please fit the wheel assemblies as per the diagram. Any other position may affect
the stability of the heater.
WARNING: Only operate the heater in normal upright position with wheel assemblies
attached to the bottom, any other position could create a hazardous situation.