5 Fin Oil Column Heater Instruction Manual AOH15 Rev 03 To ensure proper operation of this device, please read this instruction manual carefully before using the device and keep it for further reference.
General Care and Safety Guide YOUR SAFETY IS IMPORTANT TO US. PLEASE ENSURE YOU TAKE NOTE OF THE INSTRUCTIONS AND WARNINGS OUTLINED IN THIS MANUAL. CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
• • • • • • • • • • • • • • • • • • • • • • • • • Ensure hands are dry before handling the plug or main unit. Ensure appliance is on a flat, stable, heat-resistant surface. Do not operate with cord set coiled up as a heat build up is likely, which could be sufficient to become a hazard. Carry out regular checks of the supply cord to ensure no damage is evident Do not operate this appliance with a damaged cord, plug or after the appliance malfunctions or has been dropped or damaged in any manner.
COMPONENTS Main Body x1 U-shape Bolt x2 Wing Nut x 4 DIAGRAM 5 Fin Castor Plates x2 Castor Wheels x4
ASSEMBLY 1. Remove the dome nut from the castors, fit castor thread through the castor mounting plate. Replace dome nut and tighten. 2. Place the heater body upside-down on a scratch-free location, make sure it is stable and will not fall. Be careful to prevent damage to the cosmetic finish or your floor surfacing. 3. Unscrew the wing nuts from the U-shaped bolt provided (image 1), fit the Ushaped bolt over the connector between control panel and second fin (image 2). 4.
Operating your Heater Always choose a safe location for the heater, keeping in mind the safety precautions outlined. Ensure all packaging has been removed from the unit before use. Please follow the below instructions. WARNING: In order to avoid overheating or fire, do not cover the heater. WARNING: Keep all objects at least 1 metre from the front, sides and rear of the appliance.
Safety Devices This appliance has three protection devices: • • • Tilt Switch - this will automatically turn the appliance off if the appliance is not in the correct operating position. Resettable Thermal Protection - this will automatically disconnect the power to the appliance at a pre-set overheat temperature. After cooling down it will reset and power back on again. If this occurs, investigate what is causing the appliance to overheat.
Kmart Australia Ltd warrants your new product to be free from defects in materials and workmanship for the period stated above, from the date of purchase, provided that the product is used in accordance with accompanying recommendations or instructions where provided. This warranty is in addition to your rights under the Australian Consumer Law. Kmart will provide you with your choice of a refund, repair or exchange (where possible) for this product if it becomes defective within the warranty period.
READ ME FIRST Oil Column Heater Please read these instructions & user manual carefully. 1. Keep all objects at least 1 metre from the front, sides and rear of the heater. Do not place appliance close to radiant heat source. 2. Never cover this heater. Covering the heater will cause activation of the non resettable safety fuse. 3. It is recommended that this appliance is plugged directly into the wall socket. Power boards are not rated to supply power to high wattage appliances. 4.
