User's Manual

3
1 General Safety Information
Do not make any changes or settings
that are not described in this user manual.
Physical injury or damage to the device
or loss of data can result from improper
handling. Take note of all warnings and
safety notes indicated.
Setting up the Device
The device is exclusively for indoor use.
To avoid possible injuries to persons or
damage to the device itself, the device
should be placed securely on a stable,
flat surface. Position all cables in such a
way that no one will stumble on them.
Do not plug in the device in moist rooms.
Never touch the mains cable of the
mains connection with wet hands.
The device must have sufficient
ventilation and may not be covered. Do
not put your device in closed cabinets or
boxes.
Do not place the machine on soft
surfaces such as tablecloths or carpets
and do not cover the ventilation slits.
Otherwise the device could overheat or
catch fire.
Protect the device against direct sunlight,
heat, large temperature fluctuations and
moisture. Do not place the device in the
vicinity of heaters or air conditioners.
Observe the information on temperature
and humidity in the technical data.
When the device is running for a long
period of time, the surface becomes hot
and a warning symbol appears on the
projection. Then the device switches
automatically to stand by mode when it
gets too hot. After the device has cooled
down, you can continue playback by
pressing any key.
Do not allow liquids to enter into the
device. Switch off the device and
disconnect it from the mains supply if
liquids or foreign substances end up
inside the device. Have the unit
inspected by a technical service
department.
Always handle the unit with care. Avoid
touching the lens. Never place heavy or
sharp objects on the projector or the
power cable.
If the projector gets too hot or emits
smoke, shut it down immediately and
unplug the power cable. Have the device
examined by trained professionals at a
technical service location. To prevent the
spread of fire, open flames should be
kept away from the device.
Under the following conditions, a layer of
moisture can appear inside the device
which can lead to malfunctions:
※ if the device is moved from a cold to a
warm area;