Instruction Manual

Anitoa Biotechnology (Hangzhou) Co., Ltd.
第 1 页 共 19 页
Chapter 1 Important Notes
The following basic safety measures must be observed during all phases of
operation, maintenance and repair of this instrument. Failure to observe these
measures or the warnings and precautions indicated in this manual will likely affect
the basic protection provided by the instrument. It will also undermine the safety
standards for which the instrument was designed and manufactured, as well as the
intended scope of use of the instrument.
1.1 Instrument Grounding
To ensure the personal safety of the operator, please use the manufacturer's power
adapter with a 10A three-prong grounded plug at the input. Use a ground socket matching
the plug to ensure that the input power cable of the instrument is reliably grounded.
1) Use of power supply
Before the instrument adapter is connected to the power cord, you must ensure
that the voltage (100 to 240 VAC, 50/60Hz, 5A) and frequency of the AC power supply
are consistent with those required by the instrument adapter. When making the power
cord connection, you must ensure that the instrument power switch is off. Do not touch
the power switch and power cord with wet hands. It is prohibited to disconnect the
power cord when the instrument is not powered off. It is forbidden to touch the power
cord to the hot surface of the instrument. Do not clean the instrument when it is
not disconnected. Please turn off the power when the instrument is no longer in use.
2) Power cord
The instrument should normally use the power cord supplied with it. If the power
cord is broken, it must be replaced without repair. When replacing the power cord,
it must be replaced with a power cord of the same type and size. When using this
instrument, do not press anything on the power cord and do not place the power cord
in a place where people move around.
3) Power cord plugging and unplugging
Power cord plugging and unplugging must be the correct handheld plug operating
parts, plug insertion should ensure that the plug is completely, tightly inserted
into the socket, pull out the plug do not hard pull, yank the power cord.
1.2 Placement of the Instrument
1) The instrument should not be placed in a location where it is difficult to cut off the power.