Technical data

82
12/2009 Rev. 0.2
12/2009 Rev. 0.2
83
8.4.4 Cleaning the coffee grinder
Weekly clean the coffee outlet by removing it from the
grinder.
The grinder can only be cleaned by your dealer. This is
combined with half yearly maintenance.
8.4.5 Removing the entire brewer
The brewer can be entirely removed for thorough
cleaning.
Removing the brewer ( g. 49):
1. Open the door of the machine and press the open/
close brewer button. The brewer will turn into the
'open' position.
Close the door or position the service pin (see
chapter 8.1) so that the door can remain open.
Then remove the service pin so that the brewer can
be safely removed.
2. Flip up the hot water machine arm.
3. Remove the coffee outlet from the brewer.
4. Remove the waste bin.
5. Remove the water connection.
6. First pull the bottom section of the brewer towards
you to release it from the drive mechanism.
7. Lift the brewer from the suspension bracket.
8. The brewer can now be thoroughly cleaned.
9. Position the parts back into the machine in
reverse order. Caution:  rst secure the brewer into
the suspension bracket and then press the bottom
section back into the drive mechanism. Do not
forget to reconnect the water supply (5)!
10. Press the open/close brewer button. The brewer will
return to its initial position. The machine is ready for
use again.
Fig. 49
8.4.6 Cleaning the mixer unit
The mixer casing is in regular contact with the product
and must therefore be cleaned thoroughly and regularly.
If the machine is used very frequently, carry out this
cleaning procedure up to a few times a week!
Duration: approx. 5 min.
Requirements:
- Normal detergent / coffee deposit remover
- Rinsing facility
- Tea towel
- Hygiene set (for quick cleaning)
Cleaning mixer(s) ( g. 50):
1. Remove the tubes between the mixer(s) and the
outlet. Remove the ingredient canisters from the
device (turn the dispensing elements up so that no
ingredients fall out).
2. Turn the green mounting ring to the right and
remove the mixer casing by pulling it towards you.
3. Pull the mixer fan towards you to remove it from the
mixer axis and remove the green mounting ring.
4. Clean the removed parts in warm water with a
normal detergent.
5. Fit the parts in the opposite order.
CAUTION: ensure that the arrow on the
mixer fan points towards the  at side of the
axis and push the mixer fan over the axis
until you hear a clear 'click' (don't push it too
far down!).
6. Place the mixer case back onto the mixer. Turn the
green mounting ring to the left.
7. Secure the tubes between the mixer(s) and the
outlet. Place the canisters back and turn the
dispensing elements back into the correct position.
Switch the device back on and try a few test drinks
to check the correct operation.
* Use a normal detergent.
In case of persistent stains, use our tried and tested
coffee fur remover!
Clean
& dry !
1
2
3
4
5
6
7
Fig. 50
Fig. 50a
2
4
3
5
6
7
1