Technical data
80
12/2009 Rev. 0.2
12/2009 Rev. 0.2
81
8.4 Weekly cleaning
8.4.1 Cleaning the brewer lter / brewer chamber
Carry out before the daily cleaning.
Duration: approx. 5 min.
Requirements:
- Permanent lter (cleaned) (Art. No. 03488)
- Filter disassembly tool (Art. No. 03343)
1. Open the door of the machine and press the open/
close brewer button. The brewer will turn into the
'open' position.
Close the door or position the service pin (see
chapter 8.1) so that the door can remain open.
2. Remove the brewer chamber and coffee outlet.
3. Point the lter disassembly tool up all the way via
the brewer outlet.
4. Push the far end of the tool rmly against the
backside of the permanent lter until it clicks out
of the cylinder.
Clean permanent lter; see next chapter!
5. Place a clean (or new) permanent lter into the
brewer cylinder. Ensure that the protruding section
points backwards. Press the lter until it clicks into
the cylinder.
6. Clean*/rinse the brewer chamber and coffee outlet
thoroughly.
7. Place the brewer chamber and coffee outlet back
on the brewer.
CAUTION: the brewer can be severely
damaged if the brewer section is not well
SECURED when returning it to the machine.
Make sure that the wiper is always placed
BETWEEN both arms!
8. Press the brewer open/close button. The brewer
returns to its initial position. The machine is ready
for use again.
* Use a normal detergent.
In case of persistent stains, use our tried and tested
coffee fur remover!
Fig. 46
Fig. 46a
8.4.2 Brewer lter cleaning
The brewer is in constant contact with coffee. After
some time, a deposit of coffee oils, coffee particles
and minerals from the water forms on the brewer's
permanent lter. This will reduce the permeability of the
lter and therefore increase the chances of the brewer
chamber over owing.
The brewer lter must be kept in the best
possible condition by carrying out the
following cleaning procedure.
First carry out Chapter 8.4.1 Cleaning the brewer lter /
brewer chamber!
Requirements:
- Collection tray with the size of the permanent lter
- Brewer lter cleaner (Art. No. 00002)
- Brewer lter * (Art. No. 03488)
- Filter disassembly tool (Art. No. 03343)
* supplied with the machine
1. Make a solution with 1 part brewer lter cleaner
and 4 parts lukewarm water.
2. Soak the brewer lter for approx. 8-12 hours
(overnight) in the brewer lter cleaner.
3. Rinse the brewer lter thoroughly over the entire
surface.
8.4.3 Replacing the brewer lter
The machine can indicate that the brewer lter needs
replacement.
If the display shows Renew brewer lter ( g. 48),
both lters made 20.000 cups of coffee and must be
replaced as a precaution.
1. Follow the instructions of chapter 8.4.1 for replacing
the lter screen.
2. Reset the display after placing the new permanent
lter. Go to 1.5 Permanent lter of the operator
menu and reset the counter.
Art. No. permanent lter 03488
‘click’
Clean!
‘click’
2
3
8
4
1
6
5
7
Remove dirty
filter
Position cleaned
or new filter
Fig. 48
Fig. 47
8 -12 hour
1 : 4
2
3
1