User manual

Exorcist User Manual
35
Problem
Cause
Solution
My sensor is activated but
it flickers off occasionally
and disrupts my routine
This is normal. Inputs can
flicker off. It is usually
only a momentary loss of
communication
Modify your routine so its
not sensitive to such
signals, inputs should only
be used to trigger an action
and not to continuously run
an action whilst the input is
made
My DMX lights don’t
work when I try running
multiple Props
You are probably using
Parallax Servo Controllers
and an Enttec Open DMX
unit
Because VSA sees both
the Enttec and Parallax
board as the same device it
can’t tell the difference
between the PSA and the
Enttec unit, what’s
happened is the addresses
for the Enttec units have
been changed when you
plugged in the additional
PSCs, you will have to
open your routines in VSA
and change the Enttec-n
addresses to suit the new
configuration.