User manual

Exorcist User Manual
19
The Exorcist Input Box hardware description:
Features:
•!The box has four tabs for mounting.
• There are 8 red input buttons on the top surface. They are numbered from the end
where the IR Receiver plugs in. In the Exorcist software they come pre-labeled as
Input One through Input Eight. The names can be changed in the software and you
can use tape or marker pens to label the box to match.
•!Along the side are 8 mono mini-phono jacks. This is where you plug in your mat
switches or other triggering devices. The buttons and the inputs are the same. IE:
pushing on button one is the same as stepping on a mat switch connected to input one.
Do not connect any powered devices to these inputs. You will blow out the circuitry if
you do.
The jacks expect to have normally open switches connected. If your switch is
normally closed you can invert the signal in the software or define a function using the
NOT operator.
• On one end is the sub-mini phono jack for the infrared receiver.
• The opposite end has the USB connector.
• The red LED light on top lights up when The Exorcist Box is connected properly to
your PC.