User manual

Exorcist User Manual

For simplicity sake we have already named the remote keys IR RC 1, IR RC 2, etc. If

these names work for you just leave them. If you would like to use different codes or

rename them please feel free to change them. Note that when you change the name

here it also gets changed in the appropriate pull down menus on the other screens. This

can get quite confusing if you move or change the names a lot.

On the right of the MISC screen are displayed:

• The serial number of the box

• A reset button - in case the box processor crashes (not likely).

Below that are the labels for the box buttons. You can rename them here to make them

match the functions you assign to them. For example: If you play the séance routine

with button 1 you can just name the button “séance”. You can then apply a matching

label on the box to make life even easier. Masking tape and a marker pen will work

fine.

There is also an overall PC sound level adjustment on this screen.

The label control button opens a sub window where it’s possible to turn off unwanted

options in the trigger selection boxes. In its default configuration the Exorcist has over

170 options for triggers, and it may be undesirable to have them all available. When

you click the Label Management button a sub screen will be shown which lists all

trigger options. To remove unwanted trigger options just uncheck the enable checkbox

next to the trigger name and close the window, then when you open a trigger selection

box you will no longer see the unwanted trigger.

It is possible to reset all trigger options to their default setting of visible by just

clicking the reset to default button