Specifications
1
BooBox FlexMax FI-216 Operating Manual - page 22
2
BooBox Setup
The BooBox has some general settings that can be adjusted using the ScareMaster. To get to these settings,
go into the menu by holding ENABLE and tapping PLAY, then scroll down to BooBox Setup and press ENTER.
Timer (None – 31:59, default None)
Use this to trigger the Input 1 scene on a schedule. The time you set here is the time between shows.
N.C. Inputs (N.O., N.C., default N.O.)
Each trigger can be set to respond to a normally open (N.O.) or normally closed (N.C.) trigger.
N.C. Outputs (N.O., N.C., default N.O.)
Outputs 1-8 can be set to simulate a normally closed contact. This would invert the behavior of the output,
turning it off when it’s activated, and on when it’s not. This can be useful to keep a light output on by default
and have it go off when the scene turns starts.
Servos HiRange (No, Yes, default No)
Settings this to YES allows the BooBox to move servos over a 180 degree range rather than the usual 90
degrees. Use this with caution. If the servo cannot handle being pushed this far it may be damaged.
Factory Reset
Use this to reset the BooBox to its factory settings. This will reset most options, for a full reset the SD card
must also be cleared and rewritten with fresh files from our website’s Product Support section.