Specifications

1
BooBox FlexMax FI-216 Operating Manual - page 19
2
Programming Animation and Settings with the ScareMaster
Connecting the ScareMaster
The FlexMax requires your ScareMaster be at firmware version 1.20 or higher.
The version number is shown briefly in the bottom-left corner the moment the
ScareMaster powers up. If you don’t have at least version 1.20, you can
download the latest version from our website’s Product Support section.
The Basics
Idle Mode
Once the ScareMaster connects you should see a screen similar to the one above. At this point the
ScareMaster is in IDLE mode and you are in full control of the BooBox’s outputs. There is no audio in IDLE
mode, only when you are playing or recording a scene. Press PLAY to playback the current scene, or press
REC to start recording.
Controlling Outputs 9-16
When the ScareMaster is first connected you are controlling outputs 1-8. To control outputs 9-16, hold the REC
button until you see the screen display Outputs: 1-8. While still holding REC, press the UP and DN buttons to
toggle between Outputs 9-16 and 1-8, then let go of REC.
Recording a Scene
Press REC to start recording, whatever you do on the outputs will be recorded. As you record, the timer in the
bottom-right corner shows your scene position in minutes:seconds. Press REC again to stop recording.
Playing a Scene
Press PLAY to playback the current scene. Press PLAY again to stop it or let it stop automatically when it
reaches the end.
Erasing a Scene
Make sure all 8 outputs and both sliders are enabled, and then tap REC twice. Essentially all you are doing is
recording a very short empty scene.