Operating instructions

Connecting inputs: Connect the motion sensor and hand-held trigger switch (supplied with an acces-
sories pack purchased or supplied by you) to the controller by inserting the green, four-pin connector
into the match green connector on the top edge of the side board. Each trigger will alternate between
two different sequences, thus providing an element of surprise and increasing the number of triggered
routines available.
Input Receptacle Trigger received Sound That It Plays
Motion sensor First trigger Male Scream
Second trigger “Welcome”
Hand-held trigger switch First trigger “Hello children...”
Second trigger Thunderstorm
Connecting the Speakers: Plug the speakers into a receptacle that looks like a standard headphone jack
on the top edge of the side board. (Note: The speakers are not rated for outside use. You will want to
completely protect them from wet weather.)
Continuous mode vs. Trigger-only mode: You can switch the Haunted House in a Box between two
modes - continuous play and trigger-only. In continous mode the controller will play various lights and
sounds. In trigger-only mode the controller will turn all lights off and stay silent until a trigger is re-
ceived. Once the trigger has finished playing the controller will revert back to being quiet until the next
trigger has been received.
You can switch between the two different modes by depressing the Mode button on the top edge of the
side board in the controller. The “A” LED will indicate the currently selected mode.
Mode “A” LED Indicator
Continuous On
Trigger-only Off
Haunted House in a Box • Assembly and Operating Instructions
Animated Lighting, Inc. • Page 3
,OCATETHE)NPUT2ECEPTACLE
You will plug the motion sensor and
the hand-held trigger switch into this
receptacle.
,OCATETHE3PEAKER/UTPUT
You will plug the speakers into
this receptacle. It looks like a
standard headphone jack.
,OCATETHE-ODEBUTTON
Press this button to switch be-
tween the two different modes.