Operating instructions
Haunted House in a Box • Assembly and Operating Instructions
Animated Lighting, Inc. • Page 2
-AKINGTHE#ONNECTIONS
Connecting Lights: To connect your lights to the controller, locate the channel numbers 0 through 15
next to the power receptacles on the inside of the controller box. Next, run the cords from your lights into
the holes on the bottom of the box and plug each strand into the corresponding receptacle as indicated:
Channel Number Suggested Item to Plug In
0 or 8 Strobe light
1 or 9 Flood light #1
2 or 10 Flood light #2
3 or 11
Black light
4 or 12 Orange mini-lights #1
5 or 13 Orange mini-lights #2
6 or 14 Available for your lights or decorations
7 or 16 Available for your lights or decorations
NOTE: You can connect other devices to the available outputs (6, 7, 14 and 15). Just be
sure the total load at any point in time does not exceed 15 amps for channels 0-7 and 15
amps for channels 8-15.
/PENTHE"OX
,OOKFOR.UMBERS(ERE
Locate the channel numbers
0 through 15 next to the
power receptacles inside the
box.
,OCATETHECORDENTRANCES
Run the cords from your
lights into the box through
the holes on the bottom.