User manual

LOR800W & LOR160xW g3
7
small piece of duct tape over the hole in the bottom
of the unit once communication cables have been
installed. Do not seal entire unit with tape; it needs
to breath.
To connect the communications link, set the Unit
ID, access the on/off switch or change the fuses,
you must remove the front cover. The units are not
weatherproof when this cover is removed.
LOR800W Component Locations
Remove the two screws from the bottom of the front
cover, pull down and lift off the cover. Refer to the
following figure for component locations.
Configuration
Push-buttons
Status Display
Phone Cable In
Fuse
Hole for
Network Cables
CAT5 Cable In or Out
Phone Cable Out
Input Header
Figure 1
LOR800W & LOR160xW g3
8
LOR160xW Component Locations
Remove the two screws from the bottom of the front
cover, pull down and lift off the cover. Refer to the
following figure for component locations.
Status Display
Phone Cable In
Fuses
Hole for
Network Cables
Configuration
Push-buttons
CAT5 Cable In or Out
Phone Cable Out
Input Header
Figure 2
Quick Start Guide
This section gets you going in the common case
where you bought the SPK-ST Generic Start Kit
(Showtime Windows software, RS485 adapter and
Cat5 connecting cable.) You will be using the