User manual

LOR800W & LOR160xW g3

Set the number of channels to 16, the rest of the

options can be left as is and click OK. You will see

the following window:

LOR800W & LOR160xW g3

You now have a blank sequence grid with the

channels configured.

The rows in this grid represent the circuits on the

lighting controller. The “Unit 01.1” row is circuit 1,

“Unit 01.2” is circuit 2, … If you look at the output

pigtails on the controller, you will see small number

bands on each socket – these correspond to the

grid rows now.

The columns in the grid represent time increasing to

the right.

Refer back to Figure 2 if needed and click the ‘on’

tool . When you click it and then click in the grid,

it will turn ‘on’ the lights for those circuits at the

times you click. In the following example, I have

clicked to turn each light on in sequence for a 10

of a second during the first 3.1 seconds of the

sequence.